Hope this helps.Įdit2: The Y-min pin on the main controller board is empty. Please note that this is v1.1 and my printer has v1.3 although I haven't found any difference between the two, yet. On the web these printers are known as "D-force printers".Įdit1: I found this on the manufacturer's Facebook group: Here is a close-up of the Z-probe & the servo motor that pins it down.Īny help would be appreciated here. I'm unable to do so because it's not plugged into the main board. Now, while compiling the firmware, I need to specify the Z-probe pin. It can be found here, Repetier-Firmware. I've downloaded a new firmware from Repetier website. I haven't been able to find the other green board (with the HRD12008 SMPS on it), yet. I've traced the printer down to a Taiwanese manufacturer: D-FORCE.TW - 3D Printer. The brand on all these boards is "D-force". ![]() The other box with an acrylic top is a solid state relay. The other green board beside it has a DC to DC SMPS (HRD12008) on it, along with Z-min, X-min, T0, Fan-, D11 and a flat ribbon wire connector (can be seen in the picture). ![]() These are the controller boards of my printer: "Building new Repetier firmware for a delta printer (D-force) So my printer's calibration got screwed after a sudden reboot and since the current firmware (0.92.6) is licensed, I cannot edit it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |